my little project for 08' 09'

I'm pretty sure that driveway has been photoshopped - I don't see any oil stains !

Quote:

---

Originally Posted by JDNSW

One major point, I believe, is that your picture shows the thing incorrectly assembled - it should be joined with the two bolts so that the load on the weld joining the two bush tubes is in compression, and so that if this weld happened to fail the trailer would not be lost.

---

Just spin the hitch around the other way. Its probably just flipped.

BTW cucinadio, PCD also is just the diameter of the circle which would pass through the middle of all of your wheel nuts. Its usually stated as nuber of wheelnuts and the diameter of the wheel nut circle. ie the more modern Landys are 5x120mm being 5 nuts in a 120mm diameter arrangement.

Quote:

---

Originally Posted by VladTepes

I'm pretty sure that driveway has been photoshopped - I don't see any oil stains !

---

I was wondering about the tiled driveways! I must have grown up in the wrong part of town. :D

OK minor prob....tried to turn it around and it doesn't seem to want to go ...gets about 3/4 the way around and it wont go any further.....any suggestions

cheers

Quote:

---

Originally Posted by VladTepes

I'm pretty sure that driveway has been photoshopped - I don't see any oil stains !

---

:D...no!..no!....there real really:D

cheers

just did some look seeing on the info box and found its probably an old version of a AT-35 all-terrain coupling

it seem to be the same design... but alot older;)

cheers

Quote:

---

Originally Posted by cucinadio

OK minor prob....tried to turn it around and it doesn't seem to want to go ...gets about 3/4 the way around and it wont go any further.....any suggestions

cheers

---

Take out the pin it is pivoting on. Probably a good idea if it can't get the wrong way round accidentally.

John

Quote:

---

Originally Posted by JDNSW

Take out the pin it is pivoting on. Probably a good idea if it can't get the wrong way round accidentally.

John

---

is it easy to get the little pin out and replace ????

cheers

Matt have a look at this, apart from the fact the bit that attaches to the vehicle on yours is a Tregg, the trailer part is AT-35 or a copy of one, but it looks like it's the right way round.

http://www.vehiclecomponents.com.au/...New%202004.JPG