thanks to all who had a part in this production
dj
Hi guys,
I put together a PDF file of how to build yourself a drawer unit for either a D3 or D4. But of course measurements can be altered to fit any vehicle.
Many thanks to Alan to supply his plans that are included in the PDF file.
Build your own Drawer unit.pdf - File Shared from Box.net (829kb low res)
http://www.box.net/shared/jem0ilac3cner2mexq64 (3000kb - 3mb hi res)
Good luck
Regards Rich.
thanks to all who had a part in this production
dj
Well done Rich - a most professional job!
Cheers
Al
Hi Rich,
I built a drawer "system" but it is nothing on this unit, what an effort. I fitted the dual wheel carrier so I don't have to worry about the lowering of the spare wheel. I managed to get mine so I could open the rear top half of the door and get the Engle lid so it would just jam between the window and the fridge slide, this did compromise the height of the drawers slightly.
Great idea with the turnbuckles as a locating device, I removed the tie down points and through bolted the support frame to where the tie down points used to be bolted. I think I'll have to embark on a new mission, these look very professional and are ultimately easily removable.
What more can I say, thanks.
Love your work Rich
Marty you have brought up a good point which I took into consideration when looking into my options of setout.
Yes I have to drop the lower tailgate to access the fridge which normally is not a problem when camping, only when you want to quickly grab something enroute on your travels is it a bit of a pain.
I have a old ( approx 30yrs!) 29ltr Engel fridge, the motor and workings are exactly the same as the 39ltr Engel, just the height of the case is different. So this is where I came up with the idea of extending the lid of my 29 so bottles could stand vertically within it. It is actually better for me as you have easier access to contents. The lid is basically two plywood boxes with expandable foam between the two for insulation.
As you can see with the lid open it just clears the rear window and stays open by itself.
Yes with bigger fridges I'd have the fridge slide on a plywood base down low with two drawers or more on one side or purchase a drop down fridge slide:
Hi Rich! really professional looking job. I will have to get my 'Triton' woodworking system out of 'Retirement', and give it a go myself.
Could you please give us a bit more information on the carpet you used, ie; what it is, and where did you get it. I was looking at the range that my local Whitworth have in stock, but it did seem a little on the thick side.
Thanks mate,
Don.
Hi Don,
I'm not sure if you have Bunnings stores where you are but I got mine from there surprisingly. A local car trimmer I've just found also has now been able to get me some "not so thick" carpet.
Yes Bunnings!
The Whitworths stuff is a bit thicker and more expensive.
If you are a Greenie they even have synthetic grass if you want.
Search AULRO.com ONLY! |
Search All the Web! |
---|
|
|
Bookmarks