Righto, how the hell do you remove the exhaust rocker shaft from the block? The manual just says extract the shaft using part #262749. Is there an internal thread in the end of the shaft that can be engaged to draw the shaft out through the rear of the block?
Otherwise the pull-down is going ok. Everything is very sooty so looking forward to giving everything a good wash.
The engine is going in to a local machine shop on Monday (hopefully) to be measured up re bores and main bearings. They also have the machine to give it a good clean. From there I can assess further work required.
Thanks,
Chris
Chris
2014 D4 TDV6
1954 86"
1963 2A Forward Control (getting the full treatment, Isuzu 4JH1, MYY5T, LT230, Toyota Axles, extended cab ++)
1980 Stage 1 v8 (gone)
Bookmarks