Page 3 of 3 FirstFirst 123
Results 21 to 26 of 26

Thread: Advice on rust and rego please?

  1. #21
    Join Date
    Feb 2008
    Location
    Sydney via Tassie
    Posts
    105
    Total Downloaded
    0
    Thanks Blknight.
    It is hard to do a ‘proper’ REVs check because of the number miss matches.
    REVs requires VIN and engine number (at least), can’t put the VIN in alone.
    Have tried to use VIN (stamped) and the engine number (rego papers and actual) and get the following message.
    “There are no encumbrances that match the quoted identifiers.
    VEHICLE DETAILS MISMATCH WITH RTA.PLEASE CHECK IDENTIFIERS AND/OR CONSIDER
    AUVIS INSPECTION TO ENSURE VEHICLE IDENTIFIERS ARE CORRECT.
    MISMATCHED IDENTIFIERS:-“

    As an update, the seller has agreed to visit the RTA and sort out the problem and purchase a pink slip.
    If he is successful, then I should be OK.

  2. #22
    Join Date
    Jan 1970
    Location
    Canberra
    Posts
    18,616
    Total Downloaded
    0
    On the basis of the rust in your pics I think the seller will be unlikely to get a pink slip. But you never know your luck.

    Garry
    REMLR 243

    2007 Range Rover Sport TDV6
    1977 FC 101
    1976 Jaguar XJ12C
    1973 Haflinger AP700
    1971 Jaguar V12 E-Type Series 3 Roadster
    1957 Series 1 88"
    1957 Series 1 88" Station Wagon

  3. #23
    Join Date
    Feb 2008
    Location
    Sydney via Tassie
    Posts
    105
    Total Downloaded
    0
    Thanks for everyones help and advice.
    The seller has advised me that he has sold the vehicle to a buyer for parts.
    Better luck next time eh....the next search begins.
    Cheers
    Gav

  4. #24
    Join Date
    Sep 2007
    Location
    RIVERLAND, SOUTH AUSTRALIA
    Posts
    6,740
    Total Downloaded
    0
    honestly I think that worked out for the better anyway!!

    the rust would complicate any ID inspection that may be required to sort the problem out,

    the different numbers on rego papers from chassis and engine indicates to me that the rego is attached to the wrong vehicle

    anything that looks like interference in any way with a chassis number will find the owner help police to load his vehicle for conveyance and inspection re stolen vehicle...

    had someone recently in town near here tidy up engine number are on older holden by a "touch" over with angle grinder- number still readable but vehicle siezed as needed to be examined (acid i BELIEVE) to make sure... so be careful!!


    --

    take your time and now people know you are looking one may turn up quicker than you think! are you in sydney or tas?


    good luck with the hunt!
    (REMLR 235/MVCA 9) 80" -'49.(RUST), -'50 & '52. (53-parts) 88" -57 s1, -'63 -s2a -GS x 2-"Horrie"-112-769, "Vet"-112-429(-Vietnam-PRE 1ATF '65) ('66, s2a-as UN CIVPOL), Hans '73- s3 109" '56 s1 x2 77- s3 van (gone)& '12- 110

  5. #25
    Join Date
    Feb 2007
    Location
    Cooroy, QLD
    Posts
    1,396
    Total Downloaded
    0
    I agree that any engine/chassis number issues need to be avoided. I went through hell's own trouble getting our Triumph Spitfire re-registered in NSW recently (was originally a NSW car, we took it to the NT then back) because the engine number was incorrect on the RTA paperwork - right back to 1985 (thats how many old rego papers I had). Seems like someone did an engine change back then sometime but didn't update the RTA - strangely enough this had not been picked up for over 20 years, including when I took it to the NT and had it registered there - shows how useful the "pink slip" concept is (except to make cash). In the end I was lucky becuase I eventually found a reciept from 1984-ish that showed the purchase of the engine that is currently in the car (with the number recorded on the reciept). Took a fair bit of fancy letter writing and plenty of trips to the RTA to get it all sorted though!

    An issue best avoided.

  6. #26
    Join Date
    Feb 2008
    Location
    Sydney via Tassie
    Posts
    105
    Total Downloaded
    0
    Thanks to everyone for all their advice.
    I am in Sydney so if anyone knows of one for sale, please let me know.
    Cheers

Page 3 of 3 FirstFirst 123

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!