Printable View
I was just about to say "just fill it with JB Weld and ignore it" :DQuote:
Originally Posted by Shakey
Seriously, you've been hammering so you've probably started a problem anyway. Get the brute out, even if you have to remove it filing by filing (Dremels are good units)
What do people normally put in the slot then to try to turn it? I've tried a 14mm wrench sideways but this not really long enough to get much purchase!
custom made bit for an impact driver
custom filed bit of steel and a medium shifter
cut down section of a spanned with another spanner inserted to turn it
dremel
drill
pinfiles and picks
die grinder
EDM etcher
small pipe wrench
oxy kit
Well 2/3rds of it are out now, back third was corroded so it's down to getting all the crap out tomorrow and cleaning up the thread!
Is there any chemical I can use to losen up the last bits? I have most of the thread clear but the last couple of pitches have some stubborn bits I can't remove.
Lbo Grease.
freeze and release
diesel
ATF
rostoff
heat and a scribe
Do you have a thread file?
Aaron
Thanks, run out of lbo grease down to the last 2 pitches and the scribe won't grip this chunk!Quote:
Originally Posted by Blknight.aus
Didn't know they existed! Had made a tap out of a brass plug which has helped with the pickQuote:
Originally Posted by Aaron IIA