My 2a freshen up

Thanks for in put guys will try a jury rigged earth wire with a couple of alligator clips and see what happens

did a 50 mile trip today just to see what happened.......basically nothing everything held together

50 miles being quiet a chunk of the trip to Cooma coming up, gunna stretch it a bit weather permitting (no roof[bighmmm]but my wipers work[bigsmile])next Friday by driving to Orbost as I go there every Friday anyway. Will try and tee it up with local tyre joint for a wheel alignment while I'm there.

Cheers Paul

Quote:

---

Originally Posted by gromit

A bit expensive for a sensor, here's a cheaper one 545010 - Water Temperature Switch but of course out of stock !
This side of the ditch https://www.allfourx4.com.au/545010

Could it be corrosion stopping an earth path from the sensor to the head ? A long shot but removing, cleaning & replacing with some conductive grease might get it working.....but if it's not important probably best to leave it alone.


Colin

PS. Just found a modern replacement Fan Switch Kit - Otter Switch Replacement - Fosseway PerformanceFosseway Performance

---

Colin reading about your otter switch they are saying comes on at 85c my motor never seems to reach that temperature hovers around 140f or 60c could this be the issue?...

Cheers Paul

Seems the Otter switch was used in some vehicles to turn on the electric fan.
with that in mind they may have different temperature settings.
I think yours has failed or lost it's earth connection.

Colin

Jade is as ready as I can get her....hoping to find a remote master cylinder reservoir cap in Cooma and my new hydraulic brake switch should arrive Monday or Tuesday

Attachment 137984 Attachment 137985 Attachment 137986 Attachment 137987 Attachment 137988

Required ID

Attachment 137989 Attachment 137990

Cheers Paul

Beautiful !!

Stunning, great work!!

Proper Job!!!

Don't get to excited guys remember the 88 inch viewing rule[bigwhistle][bigwhistle][bigrolf]

See ya's in Cooma

Cheers Paul

Wow! Beautiful!

Paul

Looks great.

I didn't get mine finished but will bring it to Cooma anyway. (Perhaps you can give me a few pointers as to how to finish off).

See you there.

Angus