-
22nd February 2018, 09:23 PM
#11
Thanks for all the replies,
I looked at getting a new shorter length bar sent from UK but it was just silly shipping. I ended up getting a local joint to cut the bar down 20mm (10 each side), my calculations said it should have enough thread, but i reckon i didn't take into account how far they would over thread a hole(As in if the hole had to be 60mm for the tie rod end, then you make the hole 80mm but it appears you just thread 75ish mm). So i might still need to cut down one or both tie rod ends by~5mm, but right now its on the car just for test fitting and they look good.. but their heavy :P. Now i need to find a place close by that can to the steering centering and alignment.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Search AULRO.com ONLY!
|
Search All the Web!
|
Bookmarks