-
31st May 2020, 10:46 AM
#1
Bulkhead measurement needed
Hey all - I wonder if someone could take a measurement from their IIA 4 Cylinder bulkhead for me? I need to know the width of the strip that forms the bellhousing cover, as shown in the pic. Also need to confirm it's a uniform width all the way across.
RNF0010.jpg
Cheers,
Adam
-
31st May 2020, 02:05 PM
#2
Hi
69mm here, same to the bottom, and stays 69mm to the top bolt hole.
At the bend where the ruler is pointing it starts to widen
Then it’s 80mm at this point.
It continues to widen as it continues to the floor to maintain a vertical edge.
-
31st May 2020, 02:23 PM
#3
Brilliant! Thanks so much. Now I can get on with finishing my bulkhead conversion from 6cyl to 4cyl.
Cheers,
Adam
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Search AULRO.com ONLY!
|
Search All the Web!
|
Bookmarks