Results 1 to 3 of 3

Thread: Bulkhead measurement needed

  1. #1
    Join Date
    Feb 2007
    Location
    Cooroy, QLD
    Posts
    1,383
    Total Downloaded
    0

    Bulkhead measurement needed

    Hey all - I wonder if someone could take a measurement from their IIA 4 Cylinder bulkhead for me? I need to know the width of the strip that forms the bellhousing cover, as shown in the pic. Also need to confirm it's a uniform width all the way across.

    RNF0010.jpg

    Cheers,

    Adam

  2. #2
    Join Date
    Apr 2019
    Location
    South Australia
    Posts
    413
    Total Downloaded
    0
    Hi


    69mm here, same to the bottom, and stays 69mm to the top bolt hole.


    At the bend where the ruler is pointing it starts to widen


    Then it’s 80mm at this point.

    It continues to widen as it continues to the floor to maintain a vertical edge.

  3. #3
    Join Date
    Feb 2007
    Location
    Cooroy, QLD
    Posts
    1,383
    Total Downloaded
    0
    Brilliant! Thanks so much. Now I can get on with finishing my bulkhead conversion from 6cyl to 4cyl.

    Cheers,

    Adam

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!