help with chassis number

Quote:

---

Originally Posted by JDNSW

Yes - but that is where the factory stamped it, not Qld Transport! I know about this because my 2a has a number assigned by NSW RTA because they could not find the number - and their number was stamped on the chassis above the RH rear wheel. But that does not mean that Qld Transport would use the same location! It could be anywhere.

John

---

Yes - just because the Qld mob couldn't find the original number doesn't mean that it isn't there and weeds has located part of the Qld issued number, however I would still be trying to identify the original number and looking in the factory locations first. That way you know which animal you have got.

Diana

the queensland transport number is right where the original one should be, LH rear spring hanger area

i will have a closer look at the RH front

righto have the following

Q1NVAAA71Y023 stamped on the chassis
143901556 stamped on the spring hanger bit welded to the chassis thanks to buffing disc
24320450H on the compliance plate in engine bay

251775305 engine number

whats all that tell me.......?

Are you sure the last digit on the engine number is a 5? it should have a suffix letter at the end.

Maybe a gearbox number may help as well? but you have to remove the tunnel to have a decent look (i did).

-EDIT- Here are the numbers from my '71 2a SWB hardtop if it is any help...

Chassis: 243 213 66H (11/71)
engine: 241 548 80A
gearbox: 255 059 36F

I got the chassis number from a plate in the engine bay, and the gearbox and engine no's from their namesakes.

Compliance plate makes it out to be a series 2a, 88" 1962-1971 export model.

Spring hanger number for Chassis is series 2, 88" 1959 export model.

And, as has been already mentioned, the Qxxxxxxxxxxxxxxx number has been issued by the QLD transport dept, when they couldn't find the number on the spring hanger.

Looks to be made up of 2 and 2a parts (not that it's a bad thing though).

oops F is at the end of the engine number

just got back from the getting its safety certificate....she passed

oh and in the mix it has a SIII gearbox........that has developed a leak today:twisted:

Congratulations Kelvin. You are officially a Series II (not IIA) owner. ;)

As Darky has said, it's a '59. I had a rush of blood to the head and check to see if it was a Command Recon, but it isn't in REMLR... :angel:

but i liked it more being a IIA :( IIA sounds cool

Weeds, it sounds a bit dodgy to me. I wreckon you should pull it to pieces and give me all the bits I need for mine :D:D:D

well bitsa is all registered, rear plate is on not sure if i will put the front one on:p

i'm going to refer to her as a 2A 12/71 model as that what she is registered as although they wanted to put series 3 :eek: into there system even though the compliance plate says 2A

even though i located the correct chassis number number i could not convince qld transport to use it instead they stuck with the one they issued years ago, even though the girl that come out to check the number could not read all the letters/numbers:angel:

its strange using the lap seat belts and not retractable, i feel kinda naked. will look into installing 3 point retractable belts....