I recently replaced my rusted top.
Got it for $110 from that ebay guy.
+$40 for the channel kit + $25. freight - so $175 all up.
(although I found a corner had been dinged in transit and had to repair that first)
It was primed ready to paint and refit.
So JohnE's contact seems a better deal.
Beware when stripping the old one, aside from the bailey channel and the rubber strip between upper and lower section, there is an angle and a couple of folded alloy pieces - these did not come in my Kit.
I was happy I took it apart gently and saved those along with all the screws.
You will also need a grey or black butyl mastic to refit the glass and channels.
Finally, the channel if screwed directly to the frame leaves a sloppy fit for the glass - the aft section moves around and doesn't sits askew.
Do a dry fit first so you can see what packing you need under the channel in order to finish with a tight (but slidable) fit.
I found that mine had some 2 sided tape in the bottom when stripping, and I needed to do it again when I reassembled it.
Hope that helps.
Rob king.

