Quote:
Originally Posted by whitehillbilly64
Made one up myself a while back!
Will measure it up and let you know later today!
Cheers, Mick.
Printable View
Quote:
Originally Posted by whitehillbilly64
Made one up myself a while back!
Will measure it up and let you know later today!
Cheers, Mick.
Billy,
Clutch alignment tool.
Don't worry about the holes or the other shoulder, as I just made it from the nearest piece of scrap steel bar I put my hand on.
Cheers, Mick.
Thanks Mick,
May even get it made out of a bit of hardwood.
Another engine question.
How do members fix the rocker cover gasket ????
Silicone it to the rocker cover, then a smear of grease on the head ????
Thanks for the replies..
whitehillbilly
Smear of grease on both sides. Also be aware that if the rubber washers inside the steel washers that hold the rocker cover on have gone hard, you will never get a good seal.Quote:
Originally Posted by whitehillbilly64
John
Thanks John,
Changed the cap rubbers, they were in the kit.
smear of grease then.
whitehillbilly
How tight should the rocker cover nuts be done up ????
Till they bottom out on the stud, or lightly, maybe 10/12 ftlbs
Thanks
Whitehillbilly
Tight enough that it doesn't leak. ;)
Thanks:)
How's your resto going.
Been a bit quiet of late ????
whitehillbilly
Yeah, it's ground to a halt. My Son works Tuesday to Saturday now, so we only have Sunday's to do anything together, and he's usually got something to do or someone to see. We were just discussing it yesterday trying to come up with a solution to get it back on track.
It took me three hrs this week, just to clean up and paint the manifold bolts.
Any way fuel pump rebuild and fitted.
wonder why they did away with the small bracket and screw, to hold the valves in place for centre punching them, as per the later ones
Also the manifolds cleaned and fitted.
Should a heat shield be fitted to the manifold using the 3 UNC holes showing in the 3rd pic. Any one have one so I could get some measurements and make one ???? Alloy or steel ????
whitehillbilly