Couple more bits to add, but getting close.
What does that rubber gromit do on the Hi/Low shaft ???? Image 3
Thanks
whitehillbilly
Printable View
Couple more bits to add, but getting close.
What does that rubber gromit do on the Hi/Low shaft ???? Image 3
Thanks
whitehillbilly
Not quite.
my daughter is 20 in October. [bighmmm]
whitehillbilly
Started on my Super Winch Over Drive.
It was fitted to Gilbert when I got him. Seemed quite quiet, unlike most.
I believe it is a later Super Winch one, because no casting Fairey name or numbers.
Did find a really rough number stamped in under the dirt. Punch marks joined like a kids dot to dot book.
Land Rover Overdrive
http://www.lrsoc.com/forum/forum_fil...e%20Manual.pdf
whitehillbilly
I removed the clutch sleeve from Gilberts old Gear box
Looking at the teeth they look nice and square with little wear.
The Mainshaft Teeth are nice and square and the bearing surface has no pits or marks, as does the bearing surface on the clutch sleeve.
With the clutch sleeve inserted into the Mainshaft, very little play felt. Quite a nice tight fit.
whitehillbilly
[thumbsupbig]
whb
Stripped and checked. All looked good except,
Need a shim kit, and a couple of flat bearings, on the mainshaft. 'O' ring and circlip kit, plus seals.
Uk or Aus supplier ????
whitehillbilly