-
So, Back to the,
Dreaded Output Shaft bearing.
Any one found an easy way to remove it ????
Also discovered From the reverse pinion and roller bearing in the gear, and 1st/2nd Syncro, its a later than A suffix, because teeth are different.
So is Gilberts Gearbox. Had a look. same set up.
Which is a bummer as bits ordered were for a suffix A, which it was thought be be some time ago, through forum discussion.
Guessing when the Gear box is Ribbed, its a later Suffix., B or C.
Thanks.
whitehillbilly
-
if this is the bearing fitted into a blind hole i think the method is to fill the hole with grease and gently tap with a rubber mallet the shaft into the hole. This will force the bearing out after a few goes.
There are internal pullers available but grease is cheaper.
Ian
Bittern
-
Number 2 In this image.
Land Rover Parts - TRANSFER BOX
Thanks.
whitehillbilly
-
Primary pinion end float
How much end float on the primary pinion. Manuals don't really give a figure. See different shims available.
Thanks.
Whitehillbilly
-
Hi
All my manuals mention a Concave Shield in front of the primary gear, but behind the Bearing.
It Is missing on My 3, S3's Was this not fitted to later gearboxes ????
whitehillbilly
