The two holes at the top of a series windscreen frame (see red circle in pic stolen from web) - are these supposed to be blocked off?
As far as I can see they would let water in that runs off the roof and this would run in the frame until it finds an outlet somewhere?
Anyone got the low down on filling or not filling these holes?
Series windscreen 2.jpg
Thanks in advance
Skiboy
89 Orange Rangie UTE - our play thing - sadly now sold
75 Rangie/Series/Hybrid - Bumblebee with a sting!!!!
2012 RRS - The new touring vehicle
'56 Series 1 with homemade welder
'65 Series IIa Dormobile
'70 SIIa GS
'76 SIII 88" (Isuzu C240)
'81 SIII FFR
'95 Defender Tanami
'58 Series II (sold)
Motorcycles :-
Vincent Rapide, Panther M100, Norton BIG4, Electra & Navigator, Matchless G80C
No need to fill them in , they are covered over by the sharks tooth frame on a soft top.
The seal not cover the hole on either side of top of screen. So on my hard top they are open and frame gets a lot of water in when rains.
might fill them then
89 Orange Rangie UTE - our play thing - sadly now sold
75 Rangie/Series/Hybrid - Bumblebee with a sting!!!!
2012 RRS - The new touring vehicle
'56 Series 1 with homemade welder
'65 Series IIa Dormobile
'70 SIIa GS
'76 SIII 88" (Isuzu C240)
'81 SIII FFR
'95 Defender Tanami
'58 Series II (sold)
Motorcycles :-
Vincent Rapide, Panther M100, Norton BIG4, Electra & Navigator, Matchless G80C
I found holes in the bottom outer edges on my S3
whitehillbilly
My seal that I installed is on the flange that has the holes for the bolts to the roof.
That is on the flange behind where the two holes are.
the surface with the two holes has nothing on it.
i did think at the time it was a fat seal for where I put it!
I think I wil seam seal fill the two holes - hopefully no more hot water on feet in summer.
skiboy
89 Orange Rangie UTE - our play thing - sadly now sold
75 Rangie/Series/Hybrid - Bumblebee with a sting!!!!
2012 RRS - The new touring vehicle
Search AULRO.com ONLY! |
Search All the Web! |
---|
|
|
Bookmarks