Page 1 of 2 12 LastLast
Results 1 to 10 of 12

Thread: steering wheel radio control button fault

  1. #1
    bk28082003 Guest

    steering wheel radio control button fault

    Looking for some advice with regard to the above. The cruise control buttons on the left are fine but the right side radio buttons are performing different functions. Eg volume down causes volume up, skip forward causes volume down. Skip back causes skip forward. Mode button is functioning correctly.
    Any advice greatly appreciated.
    BK

  2. #2
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,030
    Total Downloaded
    0
    I very recently dismantled my left switch bank because the volume up and down buttons sometimes didn't work but worked after wriggling the wheel. So far they're all working properly again and my suspicion is that there was a poor connection at one of the plugs. However button functions hadn't changed so it probably was not the same problem as your's.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

  3. #3
    Join Date
    Jan 2010
    Location
    Edmonton Alberta Canada
    Posts
    743
    Total Downloaded
    0

    Where is the plug?

    The plug you are talking about - where it it located?

    Is the connector inside the steering wheel - that is one has to remove the air bag or is the connector somewhere down the steering column or say above the brake pedal?

    I am starting to have a similar problem - that is sometimes the volume up or down does not function, but still mostly it does.

  4. #4
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,030
    Total Downloaded
    0
    Its the connector behind the airbag. It plugs into the top of the roto coupling although I also disconnected the one at the switch. I suspect the one at the roto coupling because the coupling floats about when moving the wheel whereas the one at the switch does not.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

  5. #5
    bk28082003 Guest
    Alright then. Thanks anyway. I was hoping it might be a common complaint with a relatively simple fix but maybe not so common.. cheers,

  6. #6
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,030
    Total Downloaded
    0
    You could R&R the 3 plugs under the airbag to see if there's any improvement. I'm not 100% sure but it looked as though some of the wires from the left set of switches went across to the right set. There's a circuit board in the left set but don't know about the right set as I didn't dismatle that one. Removing the airbag is a simple and quick task once you understand what is required to unclip it. There's no need to unplug the airbag if you don't want to but no dramas anyway.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

  7. #7
    Join Date
    Jan 2010
    Location
    Mont Albert, Victoria
    Posts
    143
    Total Downloaded
    0
    Hi Graeme,
    Is there a set of instructions available explaining how to remove the airbag? My left volume / tuning joy stick is not working.
    Thanks, Andy.

  8. #8
    sheerluck Guest
    Quote Originally Posted by wombathole View Post
    Hi Graeme,
    Is there a set of instructions available explaining how to remove the airbag? My left volume / tuning joy stick is not working.
    Thanks, Andy.
    Take a look here DISCO3.CO.UK - View topic - Airbag Removal

  9. #9
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,030
    Total Downloaded
    0
    I should have taken a picture of the hook guide groove as knowing it exists means that the hook can be slid with the knowledge that it can't go astray. Keep the outer end towards you so that the inner end stays in the groove as it slides, then once it wont slide any further move the outer end towards the front of the vehicle to cause the inner end to move towards the rear to engage with the spring.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

  10. #10
    Join Date
    Jan 2010
    Location
    Mont Albert, Victoria
    Posts
    143
    Total Downloaded
    0
    Thanks guys. Made the tool from a coat hanger. Popped off the airbag. Reseated the connectors and all buttons working like new again. You have to push pretty hard to get the airbag clipped back in. I didn't disconnect the battery or anything. Was a bit worried the airbag might explode. But it didn't. Photos attached. Cheers. Andy. ImageUploadedByAULRO1394342635.998096.jpgImageUploadedByAULRO1394342726.599951.jpg
    Attached Images Attached Images

Page 1 of 2 12 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!