Lets See Your Panel Mods

[**Discovery300Tdi**]

g'day all,

tomorrow i will be chopping and cutting, slicing and dicing some of my panels on Eco. pretty much need some clearence in the rear to reduce rubbing.

Soooooo lets see some of the handy works that go on with our beloved landy's. What ever you have chopped or cut put her in!!!!!!!!!!

Cheers simon.

[Slunnie]

The pic is a bit fuzzy, but this is after I trimmed the front and rear guards to fit tyres onto the Disco2




And this was the trim on the Series2 109" ute to fit tyres also.



Here is the bullbar for it that got chopped today to suit the tyres on it.



This one is an 88" taken out to 100" and the chassis shortened up and a new Xmember put in.

[**Discovery300Tdi**]

The pic is a bit fuzzy, but this is after I trimmed the front and rear guards to fit tyres onto the Disco2




And this was the trim on the Series2 109" ute to fit tyres also.



Here is the bullbar for it that got chopped today to suit the tyres on it.



This one is an 88" taken out to 100" and the chassis shortened up and a new Xmember put in.

WoW Very nice Slunnie!!!

She's coming along, so thats the original bullbar off it????

What size tyres if you dont mind me asking????

cheers simon

[Slunnie]

WoW Very nice Slunnie!!!

She's coming along, so thats the original bullbar off it????

What size tyres if you dont mind me asking????

cheers simon

Thanks

The bullbar was off a Defender 130, its an ARB bar.

The tyres on the Disco are 34x11.5-16 which spec up at 35.2"
The 109" was on 37x13.5-15 Mickey Thompson Claws (37") but is now on 37x12.5-16 Maxxis Creepy Crawlers (36.6")
The 100" is on 38.5" Denman Ground Hawgs (36")

Actually, the 100" is also coil sprung at the rear and sprung over at the front on Landcruiser axles and a 3.5V8/LT95.

This is what it started life as:


Then onto sprung over Hilux axles and 31x10.5's



and then Denman 38" Ground Hawgs


Then it was Uted, extended to 100", axles changed to Landcruiser 60 series F&R, coiled at the rear with a Rover A-frame and the Hawgs were tossed for 37" claws.





Here is the build thread on the 109" ute:
http://www.slunnie.com/phpBB/viewtopic.php't=32

and here is how the D2 guards were chopped:
http://www.slunnie.com/phpBB/viewtopic.php't=9

[long stroke]

Very nice Slunnie
Are you going to comp it??

TIM.

[**Discovery300Tdi**]

WoW she look's like she on her way on being a comp truck!!!!

[walker]

Here is my panel work. Obviously not finished yet....but give me another 3-4 years.

[**Discovery300Tdi**]

Here is my panel work. Obviously not finished yet....but give me another 3-4 years.

Ohh very nice!!! should i ask??? what have ya got left on her????
looking great though.

[dungarover]

My dodgy panelwork 'mods' Mostly to fit large tyres and /or to prevent excess panel damage (too late anyway )

Trav

[VladTepes]

You shoulda kept the tropical roof Slunnie !