Thread: What did you do on your Landy today?

Exactly what offtrack said. The link is what I used to do the job. Common? I haven't had mine long enough to know.

There was a very little bit of oil leaking out of the front and rear.

They were $25 from Opposite Lock, Rockdale. Everybody else wanted between $50-$150.

The front was a snap to get out. The rear, I had to use a long screwdriver, long enough to tap off from under the car (as you can see from the image). Mine was silicone, superglued, puttied, if not almost welded to the head. Once out, they just pushed in.

i ordered a new [used]rear door lock handle and dust seal for my d2 today. next weekend install then hopefully i can use the tail gate again. next on the list roof lining and replace cracked a pillar plastic .

I donated my entire bank balance to save an unreliable heap of sh*t P38 worth a fraction of the cost that somehow keeps me under some witchcraft mind control; without such control I'd be able to do the wise thing and dump it for a Toyota.

I then lay out a Union Jack, knelt on it and in a trance like state cut open all my veins and sacrificed whats left of my mind, body and soul to the P38 god in return for at least 3 months cost free motoring.

No exaggeration...

I did 125kph, yes i am still in shock .

Originally Posted by loanrangie

I did 125kph, yes i am still in shock .

They're good for a lot more than that

Originally Posted by loanrangie

I did 125kph, yes i am still in shock .

Lmao did you wind up the rubber band a buy tight this time

Yes it has more juice but i was overtaking while on a long incline, never needed to do it before and was quite suprised how much more revs it pulled.

Installed a Parana duel battery tray and Optima Yellow top battery in the Puma. If any of you are thinking about doing the same thing….forget it……. It’s a genuine pain in the ass job. Nothing fits as its supposed too and the one hour fitting time they claim in the instructions is grossly under estimated. Still in the end I’m chuffed that it’s all in and done properly. Next project!!!!!