What did you do on your Landy today?

Quote:

---

Originally Posted by mick88

Now that you access holes why not weld a threaded BSP socket into the holes and put a brass plug in them so that you can clean it out again if you find the need.

Cheers, Mick.

---

Thanks Mick,
Wish id thought of that b4 i welded the plates back in. Bugga.

Cheers Rod

Sent from my GT-I9507 using AULRO mobile app

Todays effort so far, ground back welds, drilled and trial fitted fuel tank mount plates for 2 x 16 gal tanks. Will weld into place a bit later. Not sure what to do about l/h rear shocky mount being a bit worn on one side. Will weld spring hangers where bolts were left loose and bushes were worn out on both l/h front mounts. Front hole is elongated a bit. Will prob weld it a bit then use die grinder to clean it out a bit.

This is easier to post pics with my phone than with my tablet.

Cheers Rod

Sent from my GT-I9507 using AULRO mobile app

Fitted BOSS air bags to my D2 and connected ARB compressor to existing valve block.Set ride height with Nanocom. All went well and fairly easy!

ABS OPTION B next.

Cheers

Draining TC fluid as we speak :cool:

Sent from my HTC One using AULRO mobile app

Giving my car some well deserved looooove ;-)

Quote:

---

Originally Posted by Disco Muppet

Draining TC fluid as we speak :cool:

Sent from my HTC One using AULRO mobile app

---

Fluid swap complete. Interestingly, when I drained the old fluid into an ice cream container, it basically filled a 2L container yet when I transferred it into the old 2L milk containers we take oil to the tip in, it only filled maybe 1.5ish litres...
Odd....
Anyway, it's much smoother and quieter to drive now, so for $20 worth of oil it's a worthwhile job, will definitely be checking that oil every service.
Don't ask me about my thrust washers though :angel:

Sent from my HTC One using AULRO mobile app

Ok this arvo i welded the fuel tank mount plates to the bulkhead outriggers. Welded up the spring hangers and left rear shocky mount. Quick undercoat. Lots of grinding tomorrow me thinks.

Cheers Rod

Sent from my GT-I9507 using AULRO mobile app

Rear roll bar's 3/4 done. Finish it in the morning and paint her up. :D
Then onto the sliders/steps,,, Shortass is having a hard time getting in and out of the truck ;)

Quote:

---

Originally Posted by Chops

Rear roll bar's 3/4 done. Finish it in the morning and paint her up. :D
Then onto the sliders/steps,,, Shortass is having a hard time getting in and out of the truck ;)

---

I didn't think you were that short Marcus :p:p:p:p:p:p

Sent from my SM-G900F using AULRO mobile app

Hehe,, apparently,,, aren't we all? ;)

No sliders today :( Finished the rear roll bar, and have made some tie down points on the top of the van to hold firewood,, annnnd maybe a little boat ;) :cool: