Page 7 of 400 FirstFirst ... 567891757107 ... LastLast
Results 61 to 70 of 4000

Thread: What did you do on your Landy today?

  1. 2nd July 2011, 11:06 AM #61
    OffTrack's Avatar
    OffTrack
    OffTrack is offline YarnMaster
    Join Date
    Feb 2011
    Location
    Brunswick, Victoria
    Posts
    3,778
    Total Downloaded
    0
    Yesterday I replaced the exhaust down pipe on D2 with one of TD5Alive's budget 409 stainless steel units. The old unit was rattling under load and once I had it out it the flex joint was very floppy. The new down pipe has made a nice improvement to level of engine drone when cruising, which was an unexpected benefit.

    While the down pipe was out I took the opportunity to replace the Turbo oil drain pipe gasket. I'd noticed a small leak a couple of weeks ago and had slated this for attention. Removing the bolts I discovered that they were finger tight at best. A new gasket and correct torque on the bolts seems to have fixed yet another leak and averted a potential disaster.

    cheers
    Paul
    Reply With Quote Reply With Quote
  2. 2nd July 2011, 01:26 PM #62
    weeds's Avatar
    weeds
    weeds is offline Swaggie
    Join Date
    Feb 2005
    Location
    Bracken Ridge - Brisbane - QLD
    Posts
    14,276
    Total Downloaded
    0
    Quote Originally Posted by weeds View Post
    Planning to do rear prop shaft uni's and drivers door handle today.....let's see how I go
    Prop shaft rebuilt but have decided to do rear output seal.....soo front wheel drive for a little longer
    Reply With Quote Reply With Quote
  3. 3rd July 2011, 08:08 AM #63
    uninformed
    uninformed is offline ForumSage
    Join Date
    Jan 1970
    Location
    Gold Coast
    Posts
    5,101
    Total Downloaded
    0
    opened the bonnet and ****ed on the engine block......apparently BMW workers did this on the M10 blocks they used in the 1.5ltr turbo f1 class...they were good for over 1000hp....hoping it helps the def some
    Reply With Quote Reply With Quote
  4. 3rd July 2011, 01:26 PM #64
    land864's Avatar
    land864
    land864 is offline Wizard
    Join Date
    May 2007
    Location
    Melbourne
    Posts
    1,532
    Total Downloaded
    0
    Got the County/Subaru seats back from the Upholsterer today ( with 30mm taken out of the front cushion height and they feel great) and bolted them back in
    Reply With Quote Reply With Quote
  5. 3rd July 2011, 02:10 PM #65
    fraser130
    fraser130 is offline Wizard
    Join Date
    May 2006
    Location
    Carlton, Melbourne
    Posts
    1,115
    Total Downloaded
    0
    I washed mine....but tomorrow I've got a few things to do...

    Fraser
    Reply With Quote Reply With Quote
  6. 3rd July 2011, 04:40 PM #66
    richard4u2 Guest
    checked the front dis pads and toped up the front uni things with gue , 85 rrc
    Reply With Quote Reply With Quote
  7. 3rd July 2011, 05:03 PM #67
    AKW
    AKW is offline Master
    Join Date
    Aug 2008
    Location
    N,E Vic
    Posts
    154
    Total Downloaded
    0
    Last 3 days. new tyres on the Disco, old ones 10 years and 99500km.
    SIIa rebuild on the stromberg carby and got the choke working.
    Always been able to start it with no choke but wow big
    diffrence.
    now to do the clutch slave cylinder again...

    Andrew

    '93 200tdi Disco
    '65 88' SIIa
    Reply With Quote Reply With Quote
  8. 3rd July 2011, 07:33 PM #68
    JayBoRover
    JayBoRover is offline Wizard
    Join Date
    Oct 2010
    Location
    Perth
    Posts
    1,191
    Total Downloaded
    0
    Water-blasted the inside of the 15" white spoked wheels I have removed from the S2a ... getting them ready for sale.
    Then I degreased and water blasted the engine bay and undercarriage of DeeDee the S2a. I also finally found the idle adjustment for the LPG and finally, after six months of putting up with a very low idle speed, got DeeDee idling nicely on gas.
    Apart from that, DeeDee got used in anger in 4WD to conquer my bonfire pile with several trailer loads of general tree droppings from around the place.

    I also picked up a Series 1 engine as a parts donor for my S1 project car. It's got a couple of things that will be useful and then it will be junked.
    Reply With Quote Reply With Quote
  9. 3rd July 2011, 07:41 PM #69
    The ho har's's Avatar
    The ho har's
    The ho har's is offline LordRover Subscriber
    Join Date
    Jan 2007
    Location
    Logan Village area S.E. QLD
    Posts
    17,686
    Total Downloaded
    0
    All on the ex-mil...pressure blasted the wings and tub..did more on the firewall..and helped a fellow aulroian solve his tray problems

    Mrs hh
    Series Landy Rescue

    Parts, welding, finger folding, Storage, Painting, Fabrication, Restorations,
    Our FB Page..
    https://www.facebook.com/SeriesLR?ref=bookmarks

    '51 80", Discovery 2, Defender 130, 101 FC + 20 other Land Rover vehicles
    Reply With Quote Reply With Quote
  10. 3rd July 2011, 08:01 PM #70
    scarry's Avatar
    scarry
    scarry is offline Swaggie
    Join Date
    Apr 2008
    Location
    Brisbane,some of the time.
    Posts
    13,888
    Total Downloaded
    0
    Drove the D2 back from a secluded fantastic camping spot in Northern NSW.D2 was faultless again,so didn't have to do anything to it..

    Well,did have to clean the rear lights as someone mentioned to me they couldn't see the blinkers working for the mud on them
    Reply With Quote Reply With Quote
Page 7 of 400 FirstFirst ... 567891757107 ... LastLast
« Defender Imperial or Metric? | In fear of catching fire, who has stories? and what to do about it? »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!