Anyone aware of any differences between RRC trailing arms and late D1 trailing arms appears the mounts on the diff are slightly the wrong size for the trailing arms on the D1
I found a comment by discowhite in http://www.aulro.com/afvb/discovery-...ling-arms.html
this makes sense as the diff end on the disco seems slight too large for the mounts on the diffQuote:
early RRC have a bigger dia tube, thin wall section, small chassis end pin and a cast diff end bush boss.
later arms have smaller dia tube (6mm smaller than the rrc) thicker wall (by 2mm) have a larger chassis end pin and a solid diff end bush boss.
Does anyone have advise on the best way to proceed. would it be worthwhile getting some trailing arms from a RRC or is that only going complicate things further. I'd rather not try and cut the brackets of one diff to weld onto the other
