Thread: disco rear diff donut guide removal

Slide hammer. Mine came out easy.

I did question afterwards why I didn't just fit the disco tailshaft. The rubber was in good nick and I don't have a lift causing bad u-joint angles. The disco shaft sliding joint was perfect, mine is rooted.

Thanks for all the advice fella's, I probably should have explained it a little more. Not knocking the donut application or anything like that just want to use the diff housing and CW&P in the front of my County with a truetrac. I am building up a HD front end with truetrac, jacmac axles and AEU2322 CV's and rather than have the vehicle off the road I will build up this one and then just change the whole shebang over. Then the front end should be almost bulletproof.