Results 1 to 9 of 9

Thread: 91 Rangie - Electrics dying in the back end.

  1. #1
    Join Date
    Oct 2003
    Location
    Montrose, Vic.
    Posts
    5,417
    Total Downloaded
    0

    91 Rangie - Electrics dying in the back end.

    Hi guys,

    I'm trying to help a mate with the electrics of his 91 Range Rover. He is slowing loosing electrical things on the inside in the rear. 8O

    First the rear demister, then the wiper and the interior light switch on the tailgate. he also tells me the rear speakers aren't working and now the rear central locking is playing funny buggers!

    Tomorrow I have the task of helping him work out what is cactus. :? :? ... all the relays have power to them and all the exterior rear lights etc are fine... I don't yet have a wiring diagram for it.... but hopefully with a bit of searching tonight I should track one down.

    My gut feeling is there is posssibly a plastic connector that has come loose in the loom somewhere. He reckons this started after he changed the fuel pump... so I was thinging of starting near there... Any suggestions here would be VERY appreciated.

    Just wondered if any of you that are Rangie experts might be able to point me to possible sources .... before I have to work down the multimeter and trace the wires thing... (which I reckon has the potential to bugger and entire sunday! :? )

    Thanks in advance if you can help.
    Mark

    Of all the things I've lost, I miss my mind the most

    2015 TDV6 D4.... the latest project... Llams, Traxide, Icom 455, Tuffant Kimberleys and Mofos.... so far.
    2012 SDV6 SE D4 with some stuff... gone...
    2003 D2a TD5...gone...
    2000 D2 V8...gone...
    https://bymark.photography


  2. #2
    Join Date
    Jan 1970
    Location
    Ferntree Gully VIC
    Posts
    10,362
    Total Downloaded
    0
    all i can say is

    good luck

    my mech took a couple of hrs just to work out why my indicators were blowning fuses
    turn out to be the hazard light switch had gone
    130's rule

  3. #3
    Join Date
    Jan 1970
    Location
    Melbourne
    Posts
    2,972
    Total Downloaded
    0
    See what happens if you apply a good earth to the back of the car. You might have power everywhere, but if things aren't earthing properly they'll be intermittent or fail.

    Find a component that doesn't work,
    check to see if there's power
    if there is, apply earth to the device
    if that works, then all you need to do is clean up your earth connectors or run an extra earth wire to the chassis/body.

    I hope it's something so simple. :wink:

  4. #4
    Join Date
    Jan 1970
    Location
    SYDNEY -in the shire.....
    Posts
    8,196
    Total Downloaded
    0
    have a look in behind the drivers side brakelight.
    was the tank removed? any chance of any wires getting pinched?

  5. #5
    Join Date
    Jan 1970
    Location
    Melbourne
    Posts
    2,972
    Total Downloaded
    0
    Well :?: Sunday is over, did you find the problem :?:
    Tell us what it was, that we may become better prognositicators :roll: and perhaps save ourselves a future dilemma :wink: .

  6. #6
    Join Date
    Feb 2004
    Location
    Williams West Aust
    Posts
    20,998
    Total Downloaded
    0
    Hi
    Does he have a good supply of RATS or MICE where he lives???????????? They love chewing wiring,if there is the scent of there wee wee in the vehicle it may be a big clue.Next to find where they are living and dining on them yummy wires.
    Andrew
    DISCOVERY IS TO BE DISOWNED
    Midlife Crisis.Im going to get stuck into mine early and ENJOY it.
    Snow White MY14 TDV6 D4
    Alotta Fagina MY14 CAT 12M Motor Grader
    2003 Stacer 525 Sea Master Sport
    I made the 1 millionth AULRO post

  7. #7
    Join Date
    Jan 1970
    Location
    Ferntree Gully VIC
    Posts
    10,362
    Total Downloaded
    0
    ROTTON LITTLE BUGGARS

    so thats what the problem was
    maybe tell him to buy some ratsak
    tape to the car :wink:
    130's rule

  8. #8
    Hellspawn Guest
    Talon block hung in the engine bay does wonders.

  9. #9
    Join Date
    Oct 2003
    Location
    Montrose, Vic.
    Posts
    5,417
    Total Downloaded
    0
    Hey Guys,

    Sorry for the slow response!

    My mates missus took the car out before I got there!. :? ..

    So we did what seemed like a good idea. ..... we sat in the sun and had a beer waiting for her...


    ......then another ( you know one is NEVER enough [img]style_emoticons/<#EMO_DIR#>/laugh.gif[/img] )




    .....and another




    ... and ... well you know how it goes!.... by the time she got back we had lost interest in the wiring big time :!: ( probably just as well...)


    I have passed on all your suggetions and will update you once we get back to it! ops:
    Mark

    Of all the things I've lost, I miss my mind the most

    2015 TDV6 D4.... the latest project... Llams, Traxide, Icom 455, Tuffant Kimberleys and Mofos.... so far.
    2012 SDV6 SE D4 with some stuff... gone...
    2003 D2a TD5...gone...
    2000 D2 V8...gone...
    https://bymark.photography


Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!