Could someone please let me know what this sign is... I had it flash last weekend when I first got in and drove off put indicators on but not light flashing on the dash but could hear them working... Then again got in the vehicle this morning and same thing any help would be appreciated..
That's normally the indication of the position of the auto gear stick - P, R, N, D, 3, 2 or1.
I've never seen the symbol that's in your picture.
Does the symbol change at all when you move the gear stick?
Roger
Yep, you're showing drive, neutral and reverse all at the same time, but I've got no idea what's causing it.
If you need to contact me please email homestarrunnerau@gmail.com - thanks - Gav.
Wet XYZ switch?
Regards Philip A
Thanks guys, it's actually a manual I have not an auto... Like I say it happened last weekend when I first started and within about 5 mins of running it disappeared.. Same again this morning when I started the vehicle.. Phillip in regards to wet XYZ switch I get the rear wiper come on when wipers on and put into reverse so thought it is correct?? Thanks for suggestions guys really appreciate it
Auto rear wiper is correct.
I would be checking for oil at the red plug on the engine ECU,it causes all sorts of strange issues.(assuming its a TD5)
ECU is located adjacent to the battery.
Andrew
DISCOVERY IS TO BE DISOWNED
Midlife Crisis.Im going to get stuck into mine early and ENJOY it.
Snow White MY14 TDV6 D4
Alotta Fagina MY14 CAT 12M Motor Grader
2003 Stacer 525 Sea Master Sport
I made the 1 millionth AULRO post
Well that has cleared that one up!LOLThanks guys, it's actually a manual I have not an auto.
Hmm, if it is providing current to a number of the LCD connections , then it may help to remove the ECU and clean both plugs , and clean the plug that is back a bit from the ECU.
Maybe you should connect a Nanocom and see what faults come up.
Regards Philip A
Thanks a lot guys I didn't even think about the ecu plugs clean.. I will have a look and see. last time I plugged the nano in, the only fault code was air flow circuit (logged high). I will keep you updated as this has only happened once a week and both times on a Saturday. This morning I did have the beeping noise as if I had left the lights on when I turn't the key to position ll to start.. Thanks again really appreciate it.
Check with your nanacom to see that your Vehicle is set to MANUAL and not AUTOMATIC, as a gremlim might have switched it over.
We have have Manuals with Auto set in the vehicles brains.
Search AULRO.com ONLY! |
Search All the Web! |
---|
|
|
Bookmarks