pro comps are $125 ea delivered!
twin tube nitro gas or twin tube foam.
The ProComp range of shock absorbers is based around a selection of twenty possible cylinder sizes, each available as ES3000 [cellular gas] or ES9000 [nitrogen gas pressurised]. The table below gives the travel, extended and collapsed lengths of these alternatives. Part numbers shown, for convenience, relate to ES3000 shocks; for ES9000 Series the first digit is changed to '9'. Dimensions given are for versions with a standard sized eye at both ends, measurements taken between eye centres. All sizes are also available with a threaded pin top mounting - in this case measurements are taken from the base of the pin [not end or chassis mounting point]. Standard bush sizes are 5/8" I.D. in rubber, but urethane or ¾" may be specified. Many sizes are also available in pin fitting at both ends, or eye top and pin bottom, as used on coil-sprung Land Rovers, Nissan etc., and special vehicle specific fittings are also included where necessary. All this means that we offer over two hundred different permutations from stock, and should be able to match your requirements for any modified vehicle or special. Please do not concern yourself with attempting to provide the correct complete part number, we will handle this!
Part Number Extended [Inches] Collapsed [Inches] Travel [Inches] Cylinder Size
3135xx
13.6
9.3
4.3
Slim
3140xx 14.0 9.3 4.7 Std.
3145xx 14.9 9.8 5.1 Slim
3155xx 15.5 10.2 5.3 Std.
3175xx 17.5 11.0 6.5 Ex-Slim
3185xx 18.6 11.7 6.9 Std.
3195xx 19.8 12.3 7.5 Std.
3205xx 20.6 12.7 7.9 Slim
3215xx 21.6 13.2 8.4 Std.
3225xx 22.5 13.7 8.8 Std.
3235xx 23.6 14.3 9.3 Std.
3245xx 24.8 14.8 10.0 Std.
3255xx 25.7 15.5 10.2 Std.
3260xx 26.0 15.4 10.6 Slim
3265xx 27.0 15.9 11.1 Std.
3275xx 27.7 16.2 11.5 Slim
3295xx 29.8 17.3 12.5 Std.
3320xx 32.8 18.8 14.0 Std.
3340xx 34.0 19.4 14.6 Std.
3360xx 36.0 21.0 15.0 Std.
Cylinder diameters: Std. = 2.36” Slim = 2.00” Ex-Slim = 1.75”
phil
