yeah, no, thats what the one I repaired had had done to it initially, but the heat soak from the exhaust manifold and the creeping it put onto the manifold works it loose.Quote:
Originally Posted by 67hardtop
you can go overbore the stock stud size by 2mm safely, I've done a few that far for helicoiling.
Okies,
An update to close the loop on this.
Sealed and re-tapped and started to reassemble expecting everything to go swimmingly.
It didn't! The re-tapped thread wouldn't torque and stripped. Along the way, another 3 studs snapped off, none of which could be removed.
Yes, I know I should have replaced the studs, but was in a rush to get it back together and registered!
So.
Today I'm removing the head off my donor (which had overheated) and I'm going to have it hardness tested and hopefully skimmed.
If that head has lost hardness or is too warped, I'll weigh up the cost of having the head with broken studs sent to a place that does metal disintegration, then welded and re-threaded, or sourcing a replacement head.
Cheers
Ralph