Results 1 to 4 of 4

Thread: Help Required.. M & S lights flashing...

  1. 9th February 2007, 02:14 PM #1
    5teve
    5teve is offline Wizard
    Join Date
    Oct 2006
    Location
    kinross, Perth, WA
    Posts
    1,573
    Total Downloaded
    0

    Help Required.. M & S lights flashing...

    Hi Guys...

    Just been to pick some oil up and while talking commented on the fact i had had no troubles with my disco..

    well got in it.. tried to start it twice both times with nothing happening.. noticed that it wasnt quite in 'P' so shoved it properly into park and it started... went to pull off and noticed it was a bit sluggish.. looked at the dash and lo and behold M & S lights are flashing at me..

    i turned the engine off.. maybe for about 5-10 secs back on... stil lthe same....

    while driving i dont seem to have first or 4th gear... torque convertor wont lockup either. im pretty sure it starts in second and changes to 3rd.. but then thats it.. i also cannot manually select any gear....

    i guess my cry is... HELP!

    As always any info very much appreciated..

    Thanks

    Steve
    Reply With Quote Reply With Quote
  2. 9th February 2007, 02:35 PM #2
    JES Guest
    Steve, you almost solved it yourself. The problem was that it wasn't quite hard in Park and it goes into "Limp Mode" S&M flashing and the auto in 3rd gear. So place it firmly in park, take the key out of the steering column for a minute, then try starting again. All sould be fine.
    John
    Reply With Quote Reply With Quote
  3. 9th February 2007, 02:37 PM #3
    Scouse's Avatar
    Scouse
    Scouse is offline OldBushie Gold Subscriber
    Join Date
    Jan 1970
    Location
    Douglas Park, NSW
    Posts
    9,347
    Total Downloaded
    0
    It will be in fault mode whic locks the transmission in 3rd gear.

    Try locking the car up then open & start as usual.
    It can be an intermittent problem or it can happen often. Sometimes it's a poor connection.

    Under your car, check the A/C drain. It can drain straight onto the inhibitor switch & cause problems.
    Scott
    Reply With Quote Reply With Quote
  4. 9th February 2007, 02:43 PM #4
    5teve
    5teve is offline Wizard
    Join Date
    Oct 2006
    Location
    kinross, Perth, WA
    Posts
    1,573
    Total Downloaded
    0
    well if i could swear on here i would... but im not going to ... yes that was it..

    i did suspect that it was me that caused it.. but was worried it would be a trip to the stealer to get the codes removed.. Phew......

    just tried it and there are no warning lights..

    i think it was me starting it like that scouse.. i dont use the aircon... im still trying to acclimatise myself to the heat.. and im doing it the brutal way

    thanks again.. you just saved me some worry

    Steve
    Reply With Quote Reply With Quote
« D1 Fuel Pump | Why do I hear lots of bad things about the Discovery series 2? »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!