95bhp at the wheels woohoo

Quote:

---

Originally Posted by 97discotdi

I found the easiest way to adjust the boost was to install a bleed v/v in the waste gate actuator pipe, then adjust it up slowly untill you get the boost you want. The bleed v/v's can be bought from ant speed shop all the young blokes use them to adjust their Jap turbo wizzbangs, cost about $80-100.:twisted: :twisted:

---

the workshop i went to today were still trying to convince that i needed one of these fitted as they reckon this was the only way to increase the boost, even after i said it should already be set to around 15psi from the factory but all they could refer to is what that they did on toyota's and nissian's. they did acknowledge they were surprised it was already at 15psi

you are on the money as they quoted me $120 fitted

You can just get them from Industrail suppliers or Bearing suppliers as they are used for airlines.

You can get ones that are on a T that you can put inline and then just run a bleed off to your airbox and they have a locking nut under the knob so you can set it and lock it in place.

They are about $20 max and a bit ot fuel hose is all you need .