19 Spline Drive members/half-shafts

Quote:

Originally Posted by Lotz-A-Landies

Steve

You're right with the "seems" the whole LR bit of the website is quite awkward to decifer, still not sure about the outers on the front!

They "seem" to say that they are "only" available for both CV models. But very unclear if they use the original CV.
In any case it does appear that the Quaif would not have been available for the front of a pre-Stage 1 Series III so my hunt for 19 or 12 spline drive flange for the front continues (or maybe is left with the poor "arifmatick") :(

C Ya
Diana

Diana, not sure if this helps at all but quaife diffs were able to be used on earlier LRs running 4.7 diffs with the addition of this.http://www.quaife.co.uk/Crownwheel-s...sing-4-7-ratio
Its still vague as to what spline the drive members were for what outer shafts so when you have the spline number confirmed, it may be worth an email to them, I've always found them forthcoming in the past, very polite & willing to answer dopey questions. Unusual seeing as where they come from.;):D
Steve.