Thread: stereo codes for D2

Try using just '1's as the code Mat.
It should go into test mode & work for 5 minutes.

Other than that, NFI.

Dobbo

I had a problem with mine where the connector at the back wasnt connected properly and it wouldnt let me input the numbers. Try removing it and pressing on the connectors properly?

Angus

Originally Posted by McDisco

Dobbo

I had a problem with mine where the connector at the back wasnt connected properly and it wouldnt let me input the numbers. Try removing it and pressing on the connectors properly?

Angus

Tried Scouses test code so the number pad works fine

Originally Posted by Scouse

Try using just '1's as the code Mat.
It should go into test mode & work for 5 minutes.

Other than that, NFI.

Test code works, so NFI cannot get a testbook on it locally till later this week. It has to be an imobiliser issue as I am still having to use the key code to enter the vehicle.

I doubt it would be related to the immobiliser. It's just a local radio (Eurovox) that needs permanent power (for memory & retaining the code) & accessory power (so that it turns on when the key is turned to acc.).

If both of those fuses are fine, check that the appropriate power is evident at the back of the radio. Make sure the earth is good too.

It has been known for the buttons to fail. When you enter your radio code, does it recognise each button press ?

I have some standard D2 radios if all else fails - you're welcome to try one of those next time you pass Casula. If it works, it's yours.