Milford cargo barrier instructions for a D2

**grover7488** · 18th August 2008, 05:52 PM

hi there,
does anyone have Milford instructions for fitting their cargo barrier to a D2? Or are they the same as a D1? I would think not but im having trouble finding any info? Any help would be appreciated!!

**MickG** · 19th August 2008, 07:00 AM

I've got some somewhere at home.....will see if I can find them and PDF them to you.

Aye, Mick

**eckolsim** · 19th August 2008, 12:47 PM

I fitted mine and the instructions were good. The only difference I noticed was that I didn't need to drill some of the access holes for the top mounting as I was able to use get the nut plates in place using the install holes. This may not make sense yet but will when you see the instructions.

If Mick G can't find them I shall have a look around as I might still have mine.

One important note is to purchase a good quality 22mm(could be 23mm) hole saw.

**grover7488** · 21st August 2008, 07:53 PM

thanks Mick and eckolsim. I have emailed Milford and hopefully they will be able to help. If not I may take you up on the offer.

**Narangga** · 21st August 2008, 08:15 PM

Originally Posted by grover7488

thanks Mick and eckolsim. I have emailed Milford and hopefully they will be able to help. If not I may take you up on the offer.

Just put my hands on mine so give a yell if you need them.

**MickG** · 22nd August 2008, 07:09 AM

Originally Posted by Stuuu

Just put my hands on mine so give a yell if you need them.

Good job, I had a boy look for mine last night but couldn't put my hands on them..........sometimes my filing is too efficient.

Aye, Mick

**Narangga** · 22nd August 2008, 04:23 PM

Originally Posted by MickG

Good job, I had a boy look for mine last night but couldn't put my hands on them..........sometimes my filing is too efficient.

Aye, Mick

Found mine cos I haven't filed 'em

**Signal1** · 15th September 2008, 09:10 PM

All I can say is I want to throttle the idiot that thought that sliding a bit of flat steel through a drilled hole, along a bit of twin walled box section and line it all up whilst pulling on a bit of twisted fine copper was a good idea. The people that design these things...

**2 rocks** · 15th September 2008, 09:20 PM

Originally Posted by Signal1

All I can say is I want to throttle the idiot that thought that sliding a bit of flat steel through a drilled hole, along a bit of twin walled box section and line it all up whilst pulling on a bit of twisted fine copper was a good idea. The people that design these things...

Agreed...
I sooked out and got the shop to fit mine.

Mike

**p38arover** · 15th September 2008, 09:52 PM

Originally Posted by Signal1

All I can say is I want to throttle the idiot that thought that sliding a bit of flat steel through a drilled hole, along a bit of twin walled box section and line it all up whilst pulling on a bit of twisted fine copper was a good idea. The people that design these things...

Sound the same as the D1 method.

Right we need to get the instructions, scan, and file them on the 'Net.

I'll put them up on my site.

Thread: Milford cargo barrier instructions for a D2

Thread Tools

Milford cargo barrier instructions for a D2

Bookmarks

Bookmarks

Posting Permissions