I'm with you ... Could have had it out and be drinking a :beer: quicker than it took to read this Post ;)Quote:
Originally Posted by BigJon
Mike
:)
Printable View
I'm with you ... Could have had it out and be drinking a :beer: quicker than it took to read this Post ;)Quote:
Originally Posted by BigJon
Mike
:)
Toilet paper method is best, grease will leak out if there is a way and there usually is and less chance of getting grease all over the place, Regards Frank.
sharpened flat head driver used to split it along one side worked cleanly for me, the bush is very soft.
Use plasticene instead of grease and toilet paper , it works heaps better. Some engine reconditioners use this method.
Thanks guys for all the suggestions.
I removed it with a ramset masonary bolt - put it in - tightened then using a bar bell beight as a slide hammer tapped it out.
Worked a charm
Skiboy
Try one of these handy tools
No dunny paper no oil
Wouldn't be without one, Most auto tool places have em
not expensive works every time
https://www.aulro.com/afvb/images/im...09/08/1317.jpg
I used a thin chisel and broke it up. 5 minutes work.