Thread: Torque Settings

Gday

Just finished putting a new clutch master cylinder in many lumps of skin are now missing

And now its onto job No. 2. New inlet/exhaust manifold gasket, I have a Haynes manual but I can't seem to find the torque settings for the nuts.

Could someone let me know the torque settings for a 300 Tdi. Or tell me where in the book I would find them?

Thanks for your help

From RAVE ...

Exhaust manifold stud .................................................. .............................. 10Nm
Exhaust manifold nut .................................................. ............................... 45Nm
Inlet manifold stud .................................................. ..................................... 8Nm
Inlet manifold nut and bolt .................................................. ........................ 25Nm

Paul

Edit: I was too slow!