Front and rear recovery points - bolt sizes

Quote:

---

Originally Posted by Dougal

Presuming the 8.8S grade you mention is also known as HSFG?

Basically 25mm crush tubes with a 13mm hole through them are the minimum.

---

Yes, HSFG it is also called.
25x13 crush tubes, ouch! sounds like A106 SCH80 or higher pipe.
Will see if iI can find pipe lake that here.

I have an idea.
Why not post a new thread "Show us your recovery point"
or do a write up about the design of recovery points in the projects and Tutorial section.

Quote:

---

Originally Posted by Rudolf

Yes, HSFG it is also called.
25x13 crush tubes, ouch! sounds like A106 SCH80 or higher pipe.
Will see if iI can find pipe lake that here.

---

Oh I was thinking much easier to find than that.
Inch mild steel round with a hole drilled through it.:D

Or, inch mild steel round with a M12 hole tapped into it. Would have fitting advantages in some situations, through bolts would be better where you can fit them.

Found this thread.
http://www.aulro.com/afvb/general-ch...ery-point.html