Steering box drop arm nut.

Araldite is amazing stuff. The mine site that i did my apprenticeship at used to to glue crusher mandrels to the drive spindle. The guys used to mix it up in 20 ltr buckets with mixing wands attached to electric drills. The mandrels where in excess of 20t and crushed iron ore for a living. The amount of force the loctite could handle was amazing.

If you prepped the sector shaft and pitman arm properly (ie free of grease etc) you could probably glue it on with araldite and loose the nut all together....:D:p

Quote:

---

Originally Posted by BMac

......

5 minute araldite goes soft above 60 degree C, so its easy to get off in the future, if needed :D


Bruce.

---

I could see it reaching that temperature driving on bitumen on a day in the high forties.......

John

Harry Firth's crew used Araldite as head gasket sealant on the HDT Toranas.

Quote:

---

I could see it reaching that temperature driving on bitumen on a day in the high forties.......

---

True, but it regains rigidity when it cools below 60c, and its in the air stream, so I've never had a problem.

Obviously it's not the ideal fix for worn splines, but in this case it's cheap and very effective :-)

PS - I'm pretty sure it's only the Selleys 5min stuff that does this, which is why I used it.

Bruce.