Old International B250 Tractor cast iron rear wheel centre came in handy as a temporary stand until I get around to mixing up some concrete. I will put the bead breaker part back on then!
Cheers, Mick.
It's just for steel rims, mostly.
Picked one up Saturday and had a real "win".
The price was reduced from $137 down to $96 and when I went to pay for it I had $45 on my club card, so it ended up costing me $51 in the end.
Cheers, Mick.
1974 S3 88 Holden 186.
1971 S2A 88
1971 S2A 109 6 cyl. tray back.
1964 S2A 88 "Starfire Four" engine!
1972 S3 88 x 2
1959 S2 88 ARN 111-014
1959 S2 88 ARN 111-556
1988 Perentie 110 FFR ARN 48-728 steering now KLR PAS!
REMLR 88
1969 BSA Bantam B175
Old International B250 Tractor cast iron rear wheel centre came in handy as a temporary stand until I get around to mixing up some concrete. I will put the bead breaker part back on then!
Cheers, Mick.
1974 S3 88 Holden 186.
1971 S2A 88
1971 S2A 109 6 cyl. tray back.
1964 S2A 88 "Starfire Four" engine!
1972 S3 88 x 2
1959 S2 88 ARN 111-014
1959 S2 88 ARN 111-556
1988 Perentie 110 FFR ARN 48-728 steering now KLR PAS!
REMLR 88
1969 BSA Bantam B175
In case anyone else is interested in buying one...
Was just in at Supercrap to check them out as I'd seen a "club" price of $102 online. None on the floor as the store is under renovation so all the big stuff is in storage until next Saturday.
I asked whether the club price was valid until then - and when she checked found they are actually on promo this week - so even cheaper at $89
Steve
1985 County - Isuzu 4bd1 with HX30W turbo, LT95, 255/85-16 KM2's
1988 120 with rust and potential
1999 300tdi 130 single cab - "stock as bro"
2003 D2a Td5 - the boss's daily drive
I just bought one on eBay because I ordered 5 x 215/85R16 tyres on Tyroola and I know the local tyre bloke wont fit them as tubeless on my Series rims. .
$95 delivered, IKETA Tyre Changer 8"-18" Tire Bead Breaker Industrial Workshop Cars Motorbike | eBay
I bolted it to a pallet , its dead easy to break the bead and remove old tyre with the supplied bar , but stuffed if I can install new tyres with the bar thing . Tyre levers and rubber mallet easier than on the ground though.
I use Slime sealant around the bead of the tyres as a lube and it also seals the rivets .
Search AULRO.com ONLY! |
Search All the Web! |
---|
|
|
Bookmarks