Thread: Skateboard bearing runners

Andy
Go to tea transmissions.net.au I've used em plenty good people. Click on bearings. Rather than buying skate bearings buy cam followers means you don't also have to make bearing pins or bolts.

I would suggest cam followers attached to frames and draw slides made from angle channel or box even

Steve

Steve,I did see them on fleabay,looked quite useable(if a tad dear).Problem is over 2 drawers 2m long(1 kitchen,1 storage)side by side its alot of bearings.Sort of had in mind for the centre support axle bolts to have a bearing each end.
I liked the look of them,design is wizzing around between my ears at the moment,havent got to scribling on paper yet.Thinking of a stainless lid for the storage drawer,it then could be used as bench space behind the kitchen unit whilst preparing a feast
Andrew

Maybe a combo of can followers and Teflon slides once most of draw slid in and supported ?

S

Steve,I just revisited Ebay,I think they are the go.Will have a chat with my local bearing man to see what he can do with prices.My new rivnut kit could come in VERY handy using these and a rectangle tube!!!!
10X High Speed CF8 CF 8 CAM Follower Needle Roller Bearing Steel NEW | eBay
Andrew

I think you might find the shaft on them too long, especially if you are going to use a centre divider and two drawers.

I built my drawers in my troopy 15 years ago using skate board bearings on the supports and rectangle box on the side of the drawers. They are just under 2m long and with the drawer full of tools, spares and other heavy stuff I could lift my self off the ground and bounce on the end of it even when I was 135kg.

The drawers were folded out of 2m gal sheet and I put carpet inside. The top is made out of mdf and carpeted.

What are they going in to?

How wide is the area you are going to use?

Its a camper trailer.Both drawers will be around 600mm wide each.
Not yet started scribbling on paper yet,sorting what I want to do in my head at the moment.
Andrew