only advice I would give is ditch that U bolt as a tie down point main reason it is not rated and if you want to stick with it use a plate under the floor with rounded edges, you can buy rated lifting lugs on E bay and for the rear I would weld a lug to some 6mm square plate then bolt it to your floor with a matching plate under the floor, you could also weld the lugs to that angle iron on the front of your trailer.
I have a post that shows the Lugs I am using and lifting lugs have a safety factor of 4 and I am using 2.5 ton ones welded to a plate that is then welded to the chassis.
disco seriesII mods so far:-bullbar,hyd winch,
detriot locker,lsd front,C.D.L kit,chipped and bigger intercooler,2" lift,rock sliders, lsd in transfer case, modified auto trans.
In the event of nuclear war,Disregard this message
Bookmarks