I have attached a video by Timken which shows the correct procedure for repacking trailer bearings.
I can recall a relatively recent post where there was some discussion on this but Timken should know.
I do most of this but haven't used a dial indicator to see the end float, and probably not applicable when you have castellated nuts.
Regards PhilipA
Last edited by p38arover; 3rd April 2021 at 10:08 AM.
I've never seen a locking clip like that one.
The torque setting of 25ft lbs is a useful thing to know.
The next time I look at my trailer hubs, I'll try my dial test indicator to check end float.
Ron B.
VK2OTC
2003 L322 Range Rover Vogue 4.4 V8 Auto
2007 Yamaha XJR1300
Previous: 1983, 1986 RRC; 1995, 1996 P38A; 1995 Disco1; 1984 V8 County 110; Series IIA
RIP Bucko - Riding on Forever
Search AULRO.com ONLY! |
Search All the Web! |
---|
|
|
Bookmarks