Thread: td5 Disco 2 AC compressor, pully bearing's

Originally Posted by Reads90

Ok need to ask a question for my brother who is in the UK

"My pully bearing has gone and its squels when cold.

I need to replace it, I've been told its a unit replacment but thats £400 ish + tax then re-gassing is another £65 + tax . The problem is its only the little sealed bearing on the pully.

has anyone just replaced the bearing"

Cheers
Ali

Yep, these are easy, just a standard puller will do it, if you don't have a puller even a rubber mallet will do if you take it steady.

............and you don't need to do a re gas either,

Originally Posted by ladas

Yep, these are easy, just a standard puller will do it, if you don't have a puller even a rubber mallet will do if you take it steady.

............and you don't need to do a re gas either,

Cheers but where do you get the Bearing from to replace it with

Originally Posted by Reads90

Cheers but where do you get the Bearing from to replace it with

It's a standard Timken / GKN bearing

If it was here I would also go to OEX / Ingrams - but in the UK , long time since I lived there.

...........but the bearing should have the numbers stamped on it

Originally Posted by ladas

It's a standard Timken / GKN bearing

If it was here I would also go to OEX / Ingrams - but in the UK , long time since I lived there.

...........but the bearing should have the numbers stamped on it

If you hang on I will pull the OEX catalogue and get the dims

see attached

Hope it helps

Cheers for that owe you one

Ali

Will this be the same part on the V8?

yep, as long as its the same ac compressor

cheers phil