Thread: Sitec's 101..

Yeah, plan to.. Funnily enough we've had two American Spec Massey Fergys come into work (new), and in the P.D I've had to fit brake lights, AU spec indicators and a speedo... We've found some GPS speedos. All they require is an IGN fed 12v supply. They stick to the top of your dash. If anyone is interested, I'll grab the details off the box tomorrow and add it as a thread...? Will try and borrow one for a night for 'test purposes'!! Taking the 101 into work tomorrow.... on the trade plate of course!!

Yeah, would be interested in the GPS speedo details...

Me also. I suspect They'll be available in the UK?

Bet you're glad to have it running again?

Gauges, Custom Gauges, Tachometers, Speedometers, Shift Light, Pod make some cool Speedos and other gauges, lots of $$$ but completely individual to your vehicle, and they are electronic so you can fit a Speedo sensor and programme the gauge for any gearing. Some of the ones they do are GPS too

Finally got into making the fuel tanks. End plates were cut yesterday, the sheet collected. I had that cropped up to the right length, which made folding it easier this morning... Here's the RH tank, along with an air tank of a Hino FF.. Dia of 290, and length overall of 480 means it lends itself to being sat with the primary tank. You can just see in the background the shaped plates that will hold the air tank to the primary tank.

And here's a shot of both tanks laid out roughly as they will be. Both tanks match, and have ended up at 690mm long, 490mm wide, and 290mm deep. The secondary tank will have the pick up, returns, a second smaller pick up for a night heater (later planned fitment), and room behind for a pair of batteries, which gets them out of the cab!

Can you ship 2 of them back to the UK? Including air tank? Lol

We'll swap.
Send a couple of stainless steel tanks out.