Thread: 101 now called 102 ?

do me a favor and crack up the dimensions of it and I'll hit up my last few contacts in the rigging world.

http://www.nobles.com.au/overview.as...uct_id=52.html

and

http://www.nobles.com.au/overview.as...uct_id=25.html

they're what you;re after

and while Im at it...

http://www.nobles.com.au/overview.as...uct_id=47.html
43mm diameter.

hi ron
have been working on the syd harbour bridge with the riggers and have discussed your problem they recommend trying Bullans at Revesby for the best result they can do the swages etc for you ... good luck

None of the aussie companies do what is needed.
The end of the cable must be small......not much bigger than the cable.
This is what I found
Quick Attach Swageless Fittings Rigging Stay Lock Sta-Loc
Hi-MOD Fittings by Hayn Marine
It may work.
Or this
Forks and Eyes by Hayn Marine

Originally Posted by 101 Ron

None of the aussie companies do what is needed.
The end of the cable must be small......not much bigger than the cable.

That was what I found before I gave up looking. However this one from Noble might be an option. 40mm might just be small enough.

A. Noble & Son Ltd

Garry

here is the link ron these are THE guys

Bullivants Home Page - Wire Rope, Strand, Wire Rope & Strand, Fibre Rope, Chain & Fittings, Slings, Hardware, Load Restraint, Load Recovery,Personal Protection Equipment, Stainless Steel, Shackle, Shackles, sling rig, sling-rig

When I was looking for a swage I took my cable and fairleads to Bullivants but they did not have a swage small enough to fit down the fairlead fitting. The same as Nobles - unfortunately been there done that.

But maybe second time lucky/

Garry

I went to the local place which sells cable.
Yes we can get it and it is normal IWRC rope.....65 mtrs we can get in at $500.............I said I would think at about it.
The swage end I can get over seas and today I had a good look at the cable and swage end.
The cable is 9mm IWRC with six strands around a single internal one.
The swage end I can get overseas is for 3/8 rope as there is little advailable for 9mm.
Is .5 of a mm going to make a difference.
The set up it I like is the swage less system and it is a question mark if a 3/8 swage less with work on a 9mm rope.
I have better pics coming of the original swage