Thread: Wiring location for brake controller

SteveG

I have a 130 so it may not help. Sounds like i mounted unit in the same place. But I ran my cables into the fuse box then up in through behind the dash, then out throught the main wiring harness along the top of the chassy to the connector. Hope this helps. I have a TD5

There may be a better way.

Richard

After just running a bazillion new wires for various accessories, I would suggest running your cables from the trailer plug up along the left hand side of the chassis to the battery box or transmission tunnel. If you run the cable on top of the left (passenger side) chassis rail, you'll notice that there are indentations in the bodywork to leave room for wiring or pipework (the fuel lines run through these indentations on the right hand side chassis rail), and the wiring will be offered far more protection. If you need to get wiring into the cabin for the brake controller then run the cable all the way up the chassis rail into the engine bay, and bring the wire into the cab either through the grommet for the fusebox, or the grommet at the back of the speedo.

Just my two cents...

Thanks Mike.
I started to run them along the RH chassis rail, but had a niggling thought about chafed wires together with fuel lines.
I got distracted when I found my front propshaft uni joints were stuffed so gave up for the night. It was going to be a bit messy getting from the RH rail to the battery box anyway, so think I'll just pull it out again and route down the LH side.

Steve