Thread: Flat Dog flexi fare fit up.

I recently purchased some flexi flares after putting wider wheels on. I'm also reluctant to cut the original front flares. I was wondering if you remove the old flares and used a wide strip of rubber, would that fill the gap? That's what I was planning on doing. I have brush bars down the side as well. The flexi flares wont fit under them. So i probably wont fit the front flares. I didn't use the original screws, instead got some stainless bolts with allen key head. I packed out the rear with rubber washers I made with a punch set, as the recess for the screw/bolt is about 5-10mm of the body panel. Anyway, they look super tough.

JC

You could always try a wrecker, how are you going to feel about drilling holes in the panels though. I would think if you ever went back to the original flares the holes in your panels would be a bigger issue........

Thanks for pointing that out.....