Thread: Fuel pump inspection panel

Near enough.. it has to be so that the fuel lines aren't stressed.

You should be able to see daylight between the tank & the floor. You should be able to eyeball the lines. The pump itself is recessed, so that it sits on the tank bottom properly. But the lines should be enough to guesstimate the spot.

I don't know anything about the Mulgo item though, , mine was cut from a template floating around the Sydney LandRover Club (Thanks Fred!).

Regards
Max P

No it is a bit foward on my td5 and it is near a cross member under the floor.
Be careful I did mine but very hard to measure. Have sold mine now so sorry can't give you the measurements.
Lindsay

Thanks for the replies,
The hole is 200mm x 200mm so if I set it out as per instructions and then drill a hole in the middle of the of the bit to be cut out I should be able to see if I have to make any adjustments and hopefully not more than 100mm.

Cheers,
Paul.

I did this a few months ago and yes it matches the original set up.I drilled a small hole and dropped a screwdriver through which I then viewed from the left hand wheel arch.Then cut a larger hole out with the jig saw,had to partially cut out two crossmembers.200mm will be plenty mine was about 150mm.The LRA tank has a small weep some where around the cut out where it goes around the right hand chassis crossmember,so I will have to drop the tank anyway.