Thread: Auxillary electrical quirk?

This is probably going to have to be a personal battle as everything relating to this issue was put in by me so it will definitely be my fault but I though I would ask for suggestions of where to look first.

I have a double cab 110 (2004) with an alucab over the load bed.

I recently added 2 led work lights to the rear and 6 led strip lights (2 on each door/hatch). The alucab is quick release (if you have the time and the strength) and all the electricary is connected by way of a 14 pin trailer hitch. The positive feed comes from an aux battery which says it is charging and holding charge well. The strip lights are simply switched from a panel in the alucab whilst the work lights are either switched through a single relay or activated as reversing lights when the headlights are on through 2 relays. This all worked very well with the work lights being brighter than day and the strip lights being more than adaquate.

The problem with which I require assistance is:
I have just put the alucab back on after a brief "lightweight" phase and whilst the lights all work in their switched modes ( albeit with successive dimming as you switch on each light I.e. 1 strip light bright, 2 strip lights less bright etc, work lights very dim) however in the reverse mode the work lights do not come on.

I have not yet got involved with the multimeter but any suggestions of where to look or potential issues would be gratefully received.

Cheers all

John

Hi John and lucky you found the weak point.

Situations like that cause fire in worst case, so you did yourself a big favour finding the problem before it got to be a much bigger problem.