Thread: Hot trans tunnel

Assuming your heat-source is the exhaust pipe, taking a leaf out of the Jap's notebook would work. They extensively use heat shields, semi-circular 'tin' plates that are lightly supported/welded onto the top of sections of pipe. where it passes close under floors etc. Or attached to the vehicle underside.

Simple idea, intercepts the radiant heat, and being light gauge (along with thin supporting legs) it can't store much. Air-flow on both sides of the metal keeps temperature down. This is where your foil/insulation is working against you in that it's storing the heat....to let it through eventually...


Sound deadening material is never a waste in/on Deafeners...

My 2 cents worth.

Originally Posted by superquag

Assuming your heat-source is the exhaust pipe, taking a leaf out of the Jap's notebook would work. They extensively use heat shields, semi-circular 'tin' plates that are lightly supported/welded onto the top of sections of pipe. where it passes close under floors etc. Or attached to the vehicle underside. Simple idea, intercepts the radiant heat, and being light gauge (along with thin supporting legs) it can't store much. Air-flow on both sides of the metal keeps temperature down. This is where your foil/insulation is working against you in that it's storing the heat....to let it through eventually... Sound deadening material is never a waste in/on Deafeners... My 2 cents worth.

Yep I have a heat shield btw floor & muffler/exhaust. The floor is not as warm as the trans tunnel. The heat must be from the gearbox.

Hi, we travel to the NT at least once a year and the heat around the seat box and passengers floor was unbearable, especially later in the year. We successfully insulated the cab and the difference was amazing. Thai was almost 3 years age and many trips, best thing we ever did.


http://www.aulro.com/afvb/90-110-130...se-levels.html



We did the same to our Puma, you may have to troll through a few pages for more information


http://www.aulro.com/afvb/projects-t...project-9.html



Erich

In my ( & others) opinion there is limited space for air to pass between the transmission hump & gearbox. Its a basic design shortfall. Putting too much noise insulation material will make it hotter as you are reducing the ventilation, I've known of attempts to channel air there via additional scoops, vents etc. Best to put any noise suppression on the upper surface for a start.

Originally Posted by Bundalene

Hi, we travel to the NT at least once a year and the heat around the seat box and passengers floor was unbearable, especially later in the year. We successfully insulated the cab and the difference was amazing. Thai was almost 3 years age and many trips, best thing we ever did. Reducing heat and noise levels. We did the same to our Puma, you may have to troll through a few pages for more information http://www.aulro.com/afvb/projects-t...project-9.html Erich

Thanks Erich, I read that post back in 2011. I did a very similar thing to the trans tunnel. But that is where a lot of heat is still radiating from.

I will do under the seat base and floor plates.

I installed a decat pipe and wrapped the exhaust. No more hot tunnel.

Originally Posted by alittlebitconcerned

I installed a decat pipe and wrapped the exhaust. No more hot tunnel.

What's a decat pipe?

A short-ish pipe that gets rid of the pussy cat from underneath your car. Too many petrol cars have a cat in the exhaust line... getting rid of it is a Good Thing, especially as said cat converts your hot exhaust gas to hotter exhaust gas... and everything around it gets warmer.

The other comment regarding insufficient airflow between gearbox and floor underside is equally valid, and from my own Classic's behaviour I'd guess the same idiots designed Deefers... the engine room gets way too hot and what airflow there is...exits around the bell housing because there is no-where else for it to go.

Some Classic owners install 'shark-gills' on the lower/rear edge of the front mudguards and cut access holes into the engine bar. This, I'm told, makes a significant differance in floor-heat. The same idea might apply to Deafeners.