Thread: Stuck in 1st

I remember this was a common known fault with the Early Puma's. I also recall a Dealer note covering this - there were a few threads here covering this - Stuck in 1st was one of them

Not sure that it actually helps, but there is a TSB on this:

Technical Service Bulletin No.LTB00211
30 April 2009

Subject/Concern: Transmission Stuck in Gear, Selector Shaft Detents Now Available

Models: Defender (LD) 2.4 Puma Diesel 2.4 Puma Diesel VIN-range: 7A732615 Onwards

Markets: All
Section: 308-03

Summary: This Technical Bulletin is to advise that the transmission selector shaft detents are now available as a serviceable part. Therefore it is no longer necessary to replace the complete transmission assembly for concerns related to the transmission selector shaft detents (transmission stuck in gear).

Should it become necessary to replace the transmission selector shaft detents, refer to the new procedure detailed in Global Technical Reference GTR Workshop Manual, section 308-03.

Parts Required:
Description Part Number Quantity
Transmission Detent Kit LR017294 1

Labour Time:
Operation Description Operation No. Time
Selector Shaft Detents – renew 37.16.75 4.9 hours

Hi,

It's an easy 20 min fix, don't let the dealer charge you if they won't cover it under warranty,

Remove the 10mm dia vertical detent in the rear housing,

Poke a small screw driver in and flick the detent rail into neutral, I can't remember which way but it will only move one way,

Then fit the new type detent which has a stronger spring to stop it happening again,

Dave

SO here's the issue:




"We have removed the gearbox, dis-assembled and found the interlock retainer spring to be the issue, allowing the dowels to move / fall out and There fore lock into a gear, this being 1st gear."


Bye Bye $3500.

Ouch

Sorry to hear it wasn't the cheap fix imagined by Dave (AshTrans)

That's the same issue but dressed up with BS !

That was a waste of $3500 !