Page 2 of 3 FirstFirst 123 LastLast
Results 11 to 20 of 22

Thread: Leaking Defender

  1. #11
    JDNSW's Avatar
    JDNSW is online now RoverLord Silver Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    29,511
    Total Downloaded
    0
    It won't be always the same thing on every vehicle, but my experience is the major ingress point was the windscreen hinges. On yours these are not hinges but are brackets, with screws into them from inside. They are sealed by a rubber gasket that is easily damaged, or the screws may be loose.

    John
    John

    JDNSW
    1986 110 County 3.9 diesel
    1970 2a 109 2.25 petrol

  2. #12
    Join Date
    Nov 2014
    Location
    Perth, WA
    Posts
    376
    Total Downloaded
    0
    Both our Defenders leak when left in the rain. One is an MY14 and the other is an MY15. Same spot too - passengers footwell.

  3. #13
    Join Date
    Jul 2012
    Location
    ferntree gully australia
    Posts
    1,408
    Total Downloaded
    0
    Quote Originally Posted by Primalanton View Post
    Hi all. My 2004 Defender leaks - I think through the front vents when it rains which leaves big puddles of water under the pedals. I have tried a temporary fix by taping around the vents but this has not worked. Has anyone else had this problem and how have they fixed it?
    The vent seals can and do shrink , or go hard or even peal back . There an easy fix , take the flap off scrape the old seal off put stick the new one on . As for the next place to look as been mentioned the cast blocks that hold the screen to the firewall . The gasket that forms the seal shrinks letting the water track through . I made a gasket out of a cornflake box , "only temporary " that was quite a few years ago now , plus a bit of selastic . Give It a go , It's a cheep fix . Then test with a hose . good luck !!.. Jim..

  4. #14
    Didge Guest
    Quote Originally Posted by Primalanton View Post
    Well there you go! ............
    The leak occurs with only light rain so I assume there is a big gap somewhere.
    You obviously hadn't heard about the comparison test between BMW & Land Rover where both claimed there were no gaps in their seals and their cars were air and water tight.
    They both put cats in their respective cars, a BMW 750iL from memory and a standard Defender.
    A few days later they checked the cars - the cats in the BMW were dead obviously from asphyxiation and LR couldn't find the cats
    TRUE STORY!

  5. #15
    Join Date
    May 2007
    Location
    in the wild New England, NSW
    Posts
    4,918
    Total Downloaded
    0
    You could always put your raincoat on (back to front), like DC-3 (Dakota) pilots used to do when it rained

  6. #16
    Join Date
    Sep 2007
    Location
    Aussie Expat in NZ
    Posts
    3,451
    Total Downloaded
    0
    As inc said, read through the water ingress manual - if you follow it you can stop all leaks. Where they mention 'dum dum' I used 3M strip caulk. Purchased it from eBay and It is really useful stuff. I had a leak as toy described and fixed it with strip calk by pressing some into the gap between the roof and windscreen panels.

    I sealed up a lot of gaps with sikaflex - it is great stuff not doubt but once it is dry it is pretty much permanent so it is not always practical and can turn a future 5 min job into a day of bad language.. Strip caulk remains malleable
    Hercules: 1986 110 Isuzu 3.9 (4BD1-T)
    Brutus: 1969 109 ExMil 2a FFT (loved and lost)

  7. #17
    Primalanton Guest

    Leaking Defender

    Leak/s found. After much mucking around, pouring water over the most likely place for a leak and finding nothing, I was about to give up when I found a leak in the seal between the driver front door and windscreen pillar - the water ran along the bottom of the dash & dropped of over the clutch pedal thus disguising the leak!

  8. #18
    Join Date
    May 2013
    Location
    Melbourne
    Posts
    4,842
    Total Downloaded
    0
    Well done!!,...So how did you fix it?
    Pickles.

  9. #19
    Primalanton Guest
    Give me time! I have only just found it and yet to think about how to fix it!
    Me thinks it will probably be with brute force & a little bit of door adjustment.

  10. #20
    Primalanton Guest

    Fixed!

    The leaking now seems to have stopped! Thanks everyone for your help (& humour).
    I slackened off the window brackets, injected silicone in & then re- tightened, injected silicone into & under the windscreen rubber where there were minor splits. Most importantly, the door rubber, on the body, near where the window meets the panel, when pulled up, had worn/ torn under the rubber surface.
    I silicone into this area, shut the door & let it set.
    Now all good! I used blavk Dowel Corning black silicone & cleaned the residue of with detergent - wouldn't know it was there!

Page 2 of 3 FirstFirst 123 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!