Sway bars disconnects - waddya got?

Quote:

---

Originally Posted by chook73

I think the jimny ones are the way forward....

Pins would definitely make it simpler.

---

This looks good, but you'd have to be careful about the shear loading on the pin:

https://www.aulro.com/afvb/images/im...2015/04/22.jpg

It's much cleaner than this design where they arm that might hit things:

https://www.aulro.com/afvb/images/im...2015/04/21.jpg

Quote:

---

Originally Posted by RVR110

This looks good, but you'd have to be careful about the shear loading on the pin:

https://www.aulro.com/afvb/images/im...2015/04/22.jpg

---

Good luck lining the hole up....... the vehicle would have to be on a dead flat surface.

I know how hard it is to get the pin back in the bush with mine.

Quote:

---

Originally Posted by RVR110

It's much cleaner than this design where they arm that might hit things:

https://www.aulro.com/afvb/images/im...2015/04/21.jpg

---

That is the main concern, getting the angle right so it doesnt hit anything as you articulate.....

Quote:

---

Originally Posted by chook73

Good luck lining the hole up...

---

Haven't had a problem with that before...

Quote:

---

Originally Posted by RVR110

Haven't had a problem with that before...

---

:censored:

Quote:

---

Originally Posted by chook73

Good luck lining the hole up....... the vehicle would have to be on a dead flat surface.

I know how hard it is to get the pin back in the bush with mine.

---

That, and the bar is weaker by drilling a hole through it. If you fitted a 10mm bolt or pin you have almost halved its cross section. The Jimny bar is a stronger design.

Sent using the AURLO App

yeh not keen on that 2nd design, i was thinking 2 discs and 2 pins trying to keep it all small as possible and a pin on either side of the bar for strength.

For me lining them up is easy, i just jack the air spring up or down as needed ;)

Quote:

---

Originally Posted by cal415

Ive been looking for something myself for my 130, i had been thinking about trying to make something similar to the jimny bits setup but instead of bolts using an air ram and pins.

For the rear i want to have a look at mounting the sway bar above the chassis rails infront of the diff using a similar idea to the x deflex or curry anti rock kits, but need to have a good look to see if it is possible clearance wise.

---

Isn't there a ram operated one for jeeps?

Quote:

---

Originally Posted by Vern

Isn't there a ram operated one for jeeps?

---

The Jeep Rubicon has an electric disconnect. About $US1650 when purchased as a spare part:

https://www.aulro.com/afvb/images/im...2015/04/19.jpg

Just get one of those then:D